|本期目录/Table of Contents|

[1]张芳,黄志良.利用不同成孔剂制备堇青石质多孔陶瓷[J].武汉工程大学学报,2008,(03):69-71.
　ZHANG Fang,HUANG Zhi liang.Comparison of cordierite porous ceramics made from different poreforming materials[J].Journal of Wuhan Institute of Technology,2008,(03):69-71.
点击复制

利用不同成孔剂制备堇青石质多孔陶瓷(/HTML)
分享到：

《武汉工程大学学报》[ISSN:1674-2869/CN:42-1779/TQ]

卷:
期数:
2008年03期
页码:
69-71
栏目:
材料科学与工程
出版日期:
2008-03-31

文章信息/Info

Title:
Comparison of cordierite porous ceramics made from
different poreforming materials
文章编号:
10044736(2008)03006903
作者:
张芳; 黄志良
1.武汉工程大学材料科学与工程学院，湖北 武汉 430074
Author(s):
ZHANG Fang;  HUANG Zhiliang
School of Material Science and Engineering, Wuhan Institute of Technology，Wuhan 430074，China
关键词:
堇青石; 多孔陶瓷; 成孔剂; 性能与结构
Keywords:
cordierite; porous ceramics; poreforming; properties and microstructures
分类号:
TQ 174.1
DOI:
-
文献标志码:
A
摘要:
以高岭土、滑石、工业氧化铝为原料，分别用煤粉和淀粉作为成孔剂，采用压制成型工艺，在1 200℃温度下烧成，制得了具有一定气孔率的堇青石质多孔陶瓷，并将两种样品的理化性能和微观结构做了对比研究.研究表明，以淀粉为成孔剂的样品的孔分布比较均匀，孔隙率较高，但烧结强度低于以煤粉为成孔剂的样品.
Abstract:
Cordierite porous ceramics were prepared from kaolinite, talc and alumina（γ-Al2O3）, formed by pressing and fired at 1 200℃. Coal powders and starch were used as poreforming materials. Physical and chemical properties and microstructure of two samples were studied. The study results indicated that the pores of starch samples are homogeneous. Compared to coal powder samples, the porosity of starch samples is higher, but the sintering strength is lower than that of coal powder samples.

参考文献/References:

［1］曾汉民.高技术新材料要览\[M\].北京：中国科学技术出版社，1993：110.
\[2\]Peter Greil. Advanced Engineer Ceramics \[J\].Adv Mater,2002,14(10):709716.
\[3\]薛友祥.饮用水净化高性能微孔陶瓷滤芯.现代技术陶瓷，1999，(3)：1013.
\[4\]Yang Jianfeng. Fabrication of Lowshrinkage, Porous Silicon Nitride Ceramics by Addition of a Small Amount of Carbon［J］. J Am Ceram Soc, 2001, 84(7):16391641.
\[5\]SheJ H, Ohji T.Fabrication and characterization of highly porous mullite ceramics［J］. JMaterials Chemistry andhysics,2003，80：610614.
\[6\]朱时珍，赵振波，刘庆国.多孔陶瓷材料的制备技术［J］.材料科学与工程，1996，14(3)：3941.
\[7\]徐振平，郭敏.一种孔径分布能控制的多孔陶瓷\[J\].现代技术陶瓷，1996，(3)：3941.

相似文献/References:

[1]曾华,王聪,周密,等.CaCu3Ti4O12巨介电常数多孔陶瓷的制备[J].武汉工程大学学报,2010,(05):74.[doi:10.3969/j.issn.16742869.2010.05.020]
　ZENG Hua,WANG Cong,ZHOU Mi,et al.Preparation of CaCu3Ti4O12 giant dielectric porous ceramics[J].Journal of Wuhan Institute of Technology,2010,(03):74.[doi:10.3969/j.issn.16742869.2010.05.020]
[2]刘少文,尹玲玲,王文灿,等.堇青石结构化催化剂载体的研究进展[J].武汉工程大学学报,2010,(07):53.[doi:10.3969/j.issn.16742869.2010.07.014]
　LIU Shao wen,YIN Ling ling,WANG Wen can,et al.Review on structured catalyst supports[J].Journal of Wuhan Institute of Technology,2010,(03):53.[doi:10.3969/j.issn.16742869.2010.07.014]
[3]周爱军,卢琪,万香港,等.溶胶\|凝胶过程影响堇青石结晶行为的因素[J].武汉工程大学学报,2012,(06):13.[doi:103969/jissn16742869201206004]
　ZHOU Ai\|jun,LU Qi,WAN Xiang\|gang,et al.Factors affecting crystallization behavior of cordierite by Sol\|gel[J].Journal of Wuhan Institute of Technology,2012,(03):13.[doi:103969/jissn16742869201206004]
[4]徐　慢,王　亮,祝　云,等.多孔大通量莫来石相碳化硅陶瓷的制备与表征[J].武汉工程大学学报,2015,37(02):15.[doi:10. 3969/j. issn. 1674-2869. 2015. 02. 00４]
　,,et al.Ｆａｂｒｉｃａｔｉｏｎ ａｎｄ ｃｈａｒａｃｔｅｒｉｚａｔｉｏｎ ｏｆ ｂｉｇ ｆｌｕｘ ａｎｄ ｐｏｒｏｕｓ ｍｕｌｌｉｔｅ ｐｈａｓｅ ｏｆ ｓｉｌｉｃｏｎ ｃａｒｂｉｄｅ ｃｅｒａｍｉｃ[J].Journal of Wuhan Institute of Technology,2015,37(03):15.[doi:10. 3969/j. issn. 1674-2869. 2015. 02. 00４]
[5]李沁键,龚加志,肖金坤,等.烧结温度对多孔铝酸锌陶瓷性能的影响[J].武汉工程大学学报,2022,44(01):60.[doi:10.19843/j.cnki.CN42-1779/TQ.202010026]
　LI Qinjian,GONG Jiazhi,XIAO Jinkun,et al.Effect of Sintering Temperature on Properties of Porous Zinc Aluminate Ceramics[J].Journal of Wuhan Institute of Technology,2022,44(03):60.[doi:10.19843/j.cnki.CN42-1779/TQ.202010026]

备注/Memo

备注/Memo:
收稿日期：20080109
项目资助：国家自然科学基金(50774055)
作者简介：张芳（1973），女，吉林通化市人，讲师，硕士.
研究方向：多孔陶瓷的制备与表征.
更新日期/Last Update: